|
|
|
The tire rim hole measures from 33- 63 inches in diameter. Many of our customers pack dirt and gravel up to the bead in the rim, mix their own concrete and apply 4-5 inches of thickness into the bead of the tire, then cover wet concrete with water to slow cure to insure a good seal. However, bentonite, rubber belting, fiberglass or metal plate lag bolted into place and sealed with silicone caulk are also being used successfully. Your rubber water trough will resist freezing due to its thickness and color. But with some minor adjustments and a little foresight you can go a long ways toward making it a low energy or energy freeze proof trough. Here are some drawings done by one of our dealers in Montana to illustrate some successful ideas: We can also leave the tire top intact and cut drinker holes around the perimeter for livestock to drink out of. An insulated rim cover can be applied thus maximizing the insulation quality of the rubber in the trough.
|
